View Full Version : BP Husbandry
- RHP in an aquarium tank? (2 replies)
- Best way to trap heat from screened cage top (5 replies)
- Large bulge near vent? Some skin issue? (Pics) (4 replies)
- Scale Rot (16 replies)
- Big Apple Enclosures? (9 replies)
- I did it. (2 replies)
- Tubs for adult balls - height (4 replies)
- My husbandry SUCKS (29 replies)
- possible shedding issue (1 replies)
- Loose Scales (1 replies)
- First steps to treat possible RI/ wheezyness? (1 replies)
- In the midst of a Bad Shed (1 replies)
- Best Thermostat for RHP?? (16 replies)
- How often CAN I feed? (Underweight youngster) (12 replies)
- Issues with Inkbird Tstat and humidity controller (4 replies)
- Should I lift the hide before feeding my bp? (5 replies)
- RHP & Thermostat (7 replies)
- Width of heat tape for baby rack? (1 replies)
- Getting temps right at nigh.. (2 replies)
- Excessive shedding? (7 replies)
- Ball python head shed and eye caps still on- help? (3 replies)
- Do I need a new enclosure for my BP and if so, suggestions? (8 replies)
- How can I keep the humidity up? (2 replies)
- BP won't come out of hide (14 replies)
- Tight Fitting Tubs - Tricks to Slide In/Out Easier (9 replies)
- Can't get temps up high enough - should I shift the CHE? (7 replies)
- Feeding Pattern for an Underweight BP Baby? (5 replies)
- Eyelid Bump (2 replies)
- Ve-100 Thermostat fuse replacement (1 replies)
- I need help with my temps. (0 replies)
- BP Tipping Water Bowl (10 replies)
- Heat tape in my T8 - why so inefficient? (13 replies)
- Rat problem... (2 replies)
- My ball python has stuck shed but she just ate (5 replies)
- Freezer failure. Rats still 90% frozen. Safe to use? (5 replies)
- DIY Snake rack complete :) (0 replies)
- Hello! New to this forum with some questions. (7 replies)
- Help with transition (2 replies)
- First Time Feeding (5 replies)
- Ball Python Cut Himself (3 replies)
- V-18 tubs (1 replies)
- Feeding Prekilled to a BP that eats F/T (7 replies)
- Not eating. (3 replies)
- Shall I move him up a prey size? (3 replies)
- Mouth Concerns (12 replies)
- Scale rot (28 replies)
- Cataract? (2 replies)
- Exo Terra Forrest Bark causing splinters? (4 replies)
- Almost had a moment of weakness :( (11 replies)
- Agua Quandry (6 replies)
- Thermometer and T-stat readings are off? Or I'm just dumb? (7 replies)
- 28 qt tub and hides (5 replies)
- Mites in my snakes eyes (12 replies)
- T8 Set-up...Thoughts? (1 replies)
- Did I Just Make a Pizza Oven In My Enclosure? (8 replies)
- shedding (2 replies)
- First shed questions (13 replies)
- Analyze my new BP enclosure (12 replies)
- Follow Up to "I screwed up" (turns into shed question, hence the move) (1 replies)
- to anyone using Reptichip... (8 replies)
- He won't eat :(( (7 replies)
- BP Heating: I made a rookie mistake!! (4 replies)
- Can Moss in hides cause scalerot? (8 replies)
- Using a fogger for humidity (4 replies)
- Thermostat questions (3 replies)
- DIY enclosure accesories? (4 replies)
- Is vacuuming before feeding causing problems??? (5 replies)
- Retained eye caps? (20 replies)
- Switching from live mice to f/t rats !!!HELP!!! (34 replies)
- Awesome deal and question about CHE vs. Heat Lamp (7 replies)
- Question about humidifer (4 replies)
- Bp stressed???? (3 replies)
- How do you disinfect? (12 replies)
- Bad Shed/Not Eating (6 replies)
- BP won't come out of hide (7 replies)
- New to being a snake mama. Advice on setup wanted! (8 replies)
- HOUSING: rack/tub system OR T8 type? (5 replies)
- Heat Pad? (5 replies)
- My BP Dug Under His Hide? (2 replies)
- Ac and ball python (2 replies)
- The Rat Knows?? (11 replies)
- Feeding question. (1 replies)
- What size prey to offer? (2 replies)
- Not killing fuzzy rat before eating? (2 replies)
- Zombie dance or leave it? (10 replies)
- Ambient Temps finally up (2 replies)
- Will my heat lamp make my UTH hotter than it needs to be? (13 replies)
- Looking for input/pictures (6 replies)
- Aspen VS Cypress Mulch (10 replies)
- I'm getting my first BP soon and am super nervous. Tips would be appreciated! (6 replies)
- DIY rack question (16 replies)
- Can i feed my baby ball python 2 small mice in one feeding? (3 replies)
- Emergency situation (9 replies)
- New owner 2 Ball Pythons, my setup, and some questions (14 replies)
- Does a Ball Python needs 12 hours of total darkeness (2 replies)
- RHP questions (18 replies)
- Trouble breathing (7 replies)
- A new Ball Python-- But I may have some problems (22 replies)
- Do you use Reptisafe or some kind water treatment? (12 replies)
- Really want to switch, taking some steps first (6 replies)
- Normal thermoregulate behavior? (5 replies)
- Disposing of Soiled Bedding? (10 replies)
- General heating concern (16 replies)
- Recommended BP enclosure links? (4 replies)
- question about tub/rack setup and hides... (5 replies)
- baby Ball python weight concerns (8 replies)
- Proper enclosure size (2 replies)
- New to the BP world! (5 replies)
- What type of T8 cage? (13 replies)
- Feeding BP early? (4 replies)
- BP Substrate on food (6 replies)
- What enclosure for a 3 foot ball python? (12 replies)
- Thermostats: 1 per rack or 1 for a couple (1 replies)
- PLEASE HELP, my enclosure is too cold (36 replies)
- Sometbing wrong with my bp? (6 replies)
- Disenfecting Humidifier with f10? (7 replies)
- No poo for a month?? (3 replies)
- Heat Tape Question(s) (3 replies)
- had a big meal, only urates/urine? normal? (3 replies)
- Rescued Bp ? (3 replies)
- Taping Tstat Probe (24 replies)
- insulating a glass tank (7 replies)
- Ball Python Heating (1 replies)
- Placement of heat stat thermostat probe? (3 replies)
- Plastic Tub and UTH Help (17 replies)
- 30BR setup opinions wanted. (6 replies)
- Ball Python Eating (6 replies)
- Baby Ball Python keeping in heat/humidity? (6 replies)
- Need a lot of help with Husbandry (7 replies)
- Young snake won't take F/T, try live next? (40 replies)
- Help with tub temps (first time tubber & uth) (4 replies)
- 40 Gallon Breeder Tank Humidity Question (8 replies)
- Baytril use help? (17 replies)
- Tub with UTH on carpet? (3 replies)
- First feeding soon, making sure everythings ok (1 replies)
- Critique new setup (9 replies)
- Switching from f/t adult mice to f/t rats (4 replies)
- Reptifogger + inkbird wont stop fogging! (4 replies)
- Help. Female Inverted (4 replies)
- First feeding, how to go about it? (20 replies)
- Feeding question. (3 replies)
- Skinny snake (4 replies)
- Mite treatments and prevention (19 replies)
- The challenge of switching to f/t (12 replies)
- Towel for bedding? (8 replies)
- Problems with ambient heating! (3 replies)
- UTH doesn't heat up enough... (8 replies)
- Covering a cage top for humidity (5 replies)
- Getting new oil filled heater (2 replies)
- Can't create a proper heat gradient (9 replies)
- Needing a little help with a couple questions about UTH, please.. (4 replies)
- Need rack system input (6 replies)
- Tub questions (6 replies)
- Some Animal Plastics Questions (7 replies)
- Bedding question! (2 replies)
- C-serpents rack help !!! (4 replies)
- First Rat Pup Feeding Success! (6 replies)
- Ball python pooped undigested rat, help! (11 replies)
- Rat Feeding Problem (12 replies)
- Risks of live feeding (14 replies)
- Urgent problem. Regurge. (50 replies)
- Stuck Eye Cap? (5 replies)
- Heat Tape Failure (11 replies)
- Tail thickness question (11 replies)
- C Serpents Rack arriving today. (25 replies)
- Spiders (and other bugs) and ball pythons (5 replies)
- Heat Tape vs Heat Heat Pad (4 replies)
- Min. distance of CHE from snake? (12 replies)
- my ball keeps burrowing beneath the carpet in his viv. any ideas why? (32 replies)
- A couple of Shedding + Feeding Questions! (1 replies)
- Unusual behavior? (5 replies)
- Successful F/T conversion! (8 replies)
- Male BP wrapping water bowl? (4 replies)
- New female hates being handled (13 replies)
- Wiggling f/t to trigger feeding responses (aka newb owner feeding advice) (10 replies)
- Does he look fat? (12 replies)
- Feeding after removing a bad shed (1 replies)
- Regarding feeding in separate tub or in enclosure question, ponderings (7 replies)
- Got a Thermostat! But...? (10 replies)
- RHP Setup Questions (In a T8) (20 replies)
- Necks and Nougat (0 replies)
- Size and Placement of Heat Tape Questions! (5 replies)
- Browned paper towels. (4 replies)
- Anybody used a water reservoir? (3 replies)
- Trying f/t (8 replies)
- Your Opinion On Thermostats? (19 replies)
- Feeding in a separate tub vs. enclosure. (41 replies)
- Bad shed in progress. Help. (2 replies)
- 6 quart Sterilite shoebox rack questions (3 replies)
- Charlie...Charlie (sung as Caillou) (4 replies)
- How Do I Know He's Happy? (10 replies)
- Stays in cold hide ALL the time (5 replies)
- Pinkish Belly, Doesn't sit on UTH side? (22 replies)
- Question about feeding (11 replies)
- Help!!! (21 replies)
- Thermometer accuracy? (4 replies)
- CHE in a wooden viv? (1 replies)
- abuse or just a bad shed? (7 replies)
- Bioactive enclosure? (11 replies)
- heat tape probe placement? (3 replies)
- Using Heat Tape for a Tub Rack? (7 replies)
- Concern over "bathroom" location (10 replies)
- Recommendations for building BP rack system? (1 replies)
- I may have to switch back to aspen bedding. (11 replies)
- Sanity Check for Feeding Conversion (2 replies)
- Temps too cold? (13 replies)
- humidity question (3 replies)
- Time to feed? (5 replies)
- Ball Python making clicking noise and opening mouth a lot after rough shed. (1 replies)
- Need some recommendation (5 replies)
- How to use coconut husk bricks? (4 replies)
- Ball Python Not Drinking, I'm worried (11 replies)
- Should a ceramic heat emitter smell? (5 replies)
- Humidity question. (16 replies)
- ball python acting weird? (3 replies)
- Overprotective snake mom/total noob question about enclosure size (9 replies)
- Thermometer Accuracy? (21 replies)
- Should she see a vet? (3 replies)
- Is he too small? (24 replies)
- Possible RI? (3 replies)
- Types of wood safe for ball python cages to sit on. (3 replies)
- Temperature Scare (2 replies)
- Appropriate weight gain? (1 replies)
- Too big for moss in hide? (4 replies)
- Another update on Charlotte (3 replies)
- What's the earliest you can feed a younger bp? (4 replies)
- Is my BP stressed and not eating? (13 replies)
- Update on humidity (15 replies)
- How to switch from live to f/t (1 replies)
- Need to switch from live to frozen (7 replies)
- 30g Rat Pups for 115g Ball (10 replies)
- Ok guys, here's my first real question. (23 replies)
- Feed size (19 replies)
- Issues with Eco Earth humidity (8 replies)
- Any one else have that one bp that has trouble shedding? (2 replies)
- New purchase. Heating Questions. With BP Pics! (37 replies)
- Help please (30 replies)
- New ball python and have some health questions? (14 replies)
- Scent gland discharge? (8 replies)
- Tank setup (3 replies)
- A question about a substrate I found out about. (16 replies)
- My current tank set up (6 replies)
- how long does it take for respiratory infections to show symptoms (2 replies)
- Best First Rack system to buy? (17 replies)
- Handling schedule recommendations? (4 replies)
- Cold resilience (3 replies)
- Do heat mats need to be replaced eventually? (5 replies)
- Soaking (3 replies)
- Switching from tubs to rack (10 replies)
- Using a Dimmer with heat tape (7 replies)