Issues with Inkbird Tstat and humidity controller

[Ptshay]

Hi all,

Has anyone ever had:

1. The Tstat being set at say 90° but it is still getting hotter and not turning off and on to maintain the 90°? It just gets super hot and stays there? This is for a uth.

2. Same with humidity conroller- instead of humidity turning off and on to maintain the 50%, it just stays on till 99%. And keeps going until completely fogged up.

Does this sound familiar?

Sent from my SM-G930V using Tapatalk

[KMG]

Where are the probes mounted?

[Ptshay]

Where are the probes mounted?

The humidity one is on the lower half of the side of the tank on the hot side.

The temp one is under the substrate. I need to move it under the tank, on top of the uth. But that shouldn't be an issue I think right? I feel like it's the controller being screwy.

Sent from my SM-G930V using Tapatalk

[chip07]

Did you set the inkbird to have no differential? If you have have a 5 degree differential it won't turn off until it hits around 95. I have a 1 degree on mine and it's been working fine but you could have a defective probe or device.

[KMG]

The humidity one is on the lower half of the side of the tank on the hot side.

The temp one is under the substrate. I need to move it under the tank, on top of the uth. But that shouldn't be an issue I think right? I feel like it's the controller being screwy.

Sent from my SM-G930V using Tapatalk

You certainly do need to move it.