» Site Navigation
0 members and 622 guests
No Members online
Most users ever online was 47,180, 07-16-2025 at 05:30 PM.
» Today's Birthdays
» Stats
Members: 75,912
Threads: 249,118
Posts: 2,572,195
Top Poster: JLC (31,651)
Welcome to our newest member, coda
|
-
Re: Red scabby looking spot on my enchi ball python
 Originally Posted by blabbytax1
Thank you everyone for the help this is my first snake and I was worried and I still am I will try to get her into a veterinarian asap tomorrow is memorial day so I don't if anywhere will be open
Sent from my SM-G970U using Tapatalk
This is not an emergency, you'll likely pay way more to be seen tomorrow because it's a holiday. I'd wait...this doesn't look serious to me at all, unless you see changes
as I described (bleeding, oozing, lots more redness), just keep her clean & resting & at the right temps. -and use a topical antiseptic as I explained earlier.
If you're in a larger metro area or very lucky, you might have emergency vet services available, but it's WAY more important that you see the most qualified reptile
specialist, rather than whoever is on duty for holidays & weekends. Regular vets don't usually train for reptile pets, & medical care is WAY different...many things are
toxic for snakes that are good for cats & dogs...you can waste money or even do more harm than good by seeing the "wrong" vet, even if they mean well.
-
The Following User Says Thank You to Bogertophis For This Useful Post:
-
Re: Red scabby looking spot on my enchi ball python
 Originally Posted by blabbytax1
I put the arrows on it to keep it at the right temperature 
Sent from my SM-G970U using Tapatalk
That's what I figured you meant: that is a UTH controlled by a rheostat...it's not accurate, you cannot control the heat to a certain temp. with it...all you can do is
install it & let it run for a while, then keep checking back as to what temp. it's actually producing in the cage, and making adjustments to get as close as you can to
what is needed. Thermostats actually control the power to the UTH they control, either by proportionally reducing the power, or by making it go on & off to achieve
the right temps. which are read by a connected probe. So this (above) is better than nothing, but not the optimal or the safest choice.
One difference is that as your room temperature changes, a thermostat is going to adjust the temps produced, whereas that rheostat is going to stay where-
ever you dialed it, which might end up being too cold or too hot. Also, if there are power fluctuations, a rheostat may not adapt.
Last edited by Bogertophis; 05-26-2019 at 08:56 PM.
-
The Following 2 Users Say Thank You to Bogertophis For This Useful Post:
bcr229 (05-27-2019),blabbytax1 (05-26-2019)
-
Registered User
Re: Red scabby looking spot on my enchi ball python
I will probably order the one you suggested then I just wanted to make sure I get one that will work right
Sent from my SM-G970U using Tapatalk
Last edited by blabbytax1; 05-26-2019 at 09:19 PM.
-
The Following User Says Thank You to blabbytax1 For This Useful Post:
-
Registered User
Re: Red scabby looking spot on my enchi ball python
 Originally Posted by Bogertophis
There are many kinds, can you show it? If it's made for geckos it should be fine for snakes too...but I think you mean a variable temp. control, but not an actual
thermostat, right? There's a big difference, & BPs require more heat than many other herps, so it's more dangerous (as far as causing burns) if not well-regulated.
(You can't blame us for not wanting to see any more injured BPs around here...we're all animal lovers.)
I understand that you don't want to see anything injured
Sent from my SM-G970U using Tapatalk
-
The Following User Says Thank You to blabbytax1 For This Useful Post:
-
By the way...
-
The Following User Says Thank You to Bogertophis For This Useful Post:
-
Registered User
Re: Red scabby looking spot on my enchi ball python
Thanks I have all kinds of animals and i spoil all of them
Sent from my SM-G970U using Tapatalk
-
The Following User Says Thank You to blabbytax1 For This Useful Post:
-
Re: Red scabby looking spot on my enchi ball python
 Originally Posted by blabbytax1
Thanks I have all kinds of animals and i spoil all of them
Sent from my SM-G970U using Tapatalk
Just be sure to budget for them too... it's really easy, when ruled by our hearts, to get in over our heads.
Last edited by Bogertophis; 05-27-2019 at 02:40 PM.
-
The Following 2 Users Say Thank You to Bogertophis For This Useful Post:
blabbytax1 (05-27-2019),TechnoCheese (05-27-2019)
-
Registered User
Re: Red scabby looking spot on my enchi ball python
I have enough money to take care of them
Sent from my SM-G970U using Tapatalk
-
The Following User Says Thank You to blabbytax1 For This Useful Post:
-
Registered User
Re: Red scabby looking spot on my enchi ball python
I took her to the vet and they put her on a topical antibiotic and said that it was just a cut and thanks everyone for the help and advice
Sent from my SM-G970U using Tapatalk
-
The Following 3 Users Say Thank You to blabbytax1 For This Useful Post:
Bogertophis (05-29-2019),Godzilla78 (05-29-2019),Mirakuru (05-29-2019)
-
Did you figure out how she cut herself in the cage? Sometimes we have to play "detective"...
-
The Following User Says Thank You to Bogertophis For This Useful Post:
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|