Retic Cage Utopia.

[CloudtheBoa]

I have River in a T12 and they have those front pieces that split the front i to 2 small windows and I have no problems getting River out, and she's over 7'. Granted, all I have is two hides and a fake plant and nothing extravagant but she comes out easy, the front piece doesn't hinder me at all.


Sent from my iPhone using Tapatalk

[CloudtheBoa]

lol I was talking about removing the perches in a T8. Phyllis is tricky to get out if she's wrapped around anything in the cage. As I'm drawing up plans for perches in my T8s it would definitely be tight on space. I could go 5", maybe 6" off the floor but under the RHP that leaves only 3.5"-4" between perch and heat panel. How close are the perches in your 14" high pro line?


Sent from my iPhone using Tapatalk

Lol this went through the same time as my reply. In that case, yes, it could be difficult but you should be able to still get them in and out.


Sent from my iPhone using Tapatalk

[Sauzo]

If you aren't set on the natural look, go with PVC piping. They are easy to clean, easy to cut and can be made into any design. I use them for Allie as she loves her perches. And they are also free standing if you make them like a jungle gym.

[Sauzo]

I have River in a T12 and they have those front pieces that split the front i to 2 small windows and I have no problems getting River out, and she's over 7'. Granted, all I have is two hides and a fake plant and nothing extravagant but she comes out easy, the front piece doesn't hinder me at all.


Sent from my iPhone using Tapatalk

Same here, my cages are pretty plain but its easy to take anyone out and i'm using T10s. Even if the snakes go up on their shelves, its easy to slide them right off.