Animal Plastics Belly Heat

[AndrewGeibel]

I don't have a picture of the Flexwatt. I just ordered the 11 inch Flexwatt belly heat option that AP offers. They forgot to bring it to the show so they are mailing it to me and it should be here tomorrow. I assume its just regular 11 inch Flexwatt. If that is what you used then how/where did you "slide it in." I guess it is potentially possible that I could have gotten the wrong bottom as my bottom does have the grooves cut in it for the heat cable. I assumed they just had a standard code written for the CNC mill for all of the bottom options and only made one part instead of a specific one for the different heating options.

[Krazy99CL]

I don't have a picture of the Flexwatt. I just ordered the 11 inch Flexwatt belly heat option that AP offers. They forgot to bring it to the show so they are mailing it to me and it should be here tomorrow. I assume its just regular 11 inch Flexwatt. If that is what you used then how/where did you "slide it in." I guess it is potentially possible that I could have gotten the wrong bottom as my bottom does have the grooves cut in it for the heat cable. I assumed they just had a standard code written for the CNC mill for all of the bottom options and only made one part instead of a specific one for the different heating options.

The tape that they sent me is not the same as what Beanfarm sends. Its different as the sides are cut down(how its made) and it has clips and plug set up for you already. Its the same as if you where to make one yourself with the clips and clamps. nothing else different. Best sugguestion would be to call or email Ali.

I would just get some metal tape, put the probe in and tape the heat tape down and call it a day. lol.

- all in all...Other than that i would slide the sides Left and Right edges in the groves and tape them down. Use your imagination. I hope it works best this way.

[AndrewGeibel]

The tape that they sent me is not the same as what Beanfarm sends. Its different as the sides are cut down(how its made) and it has clips and plug set up for you already. Its the same as if you where to make one yourself with the clips and clamps. nothing else different. Best sugguestion would be to call or email Ali.

I would just get some metal tape, put the probe in and tape the heat tape down and call it a day. lol.

- all in all...Other than that i would slide the sides Left and Right edges in the groves and tape them down. Use your imagination. I hope it works best this way.

Cool thank you. I was planning on doing something like that. I did email Ali but it was fairly in the evening so maybe I will get a response today. I'm sure they are pretty busy after getting back from the show though. I'm sure I'll figure this thing out.