Quote Originally Posted by Danegerous View Post
HEATING UPDATE!
Ok ladies and gents, I just installed the Flex-watt and the Helix today. I played it cool and ordered only 8' of the 11" heat tape. This was a cheaper alternative and to be honest, I didn't know just how difficult it would be. I also ordered the clips, protectors and wire. The clips came clamped to the wires, so I just needed to attach em. Now, I'm an electronics nerd, so I was well prepared to solder anything, this was so easy I almost did it over just to have a challenege...

I foil taped the heat tape in 4' chunks and then plugged everything in...there was some overhang which is obvious given the lengths of the tape and the shelves. I didnt mind, I simply folded the tape up along the side on the clamp end and taped it there. no biggie, there is still plenty of room to slide the tubs in and out. This fold is also where i taped the probe, on top of some plastic to model a tub.

That's it really. If i can find out how to insert this memory card, I'll upload some pics...EDIT: these are more of the setup. If you want, I can get em of the installation, too.



Lets see it