So, I bought the zoo med snake kit, with the uth, the light, the aspen substrate, the water bowl, and the tiny “hide”. I gave the BP a bigger hide, and upgraded the substrate to one that holds moisture for humidity purposes. I believe it was coconut fiber? A guy at a local reptile shop told me it was ideal, so I used that. I bought a thermostat, and use the light during the day for ambient temps. The digital thermometer I bought registers around 82 degrees in the tank on the end that I have the light on. I put the uth under where the BPs hide is. I understand that a uth can’t heat an entire enclosure, but I know they need a “hot” contact spot, so I’m using it for that. My real concern is that the uth is getting far too hot in some spots, unless the IRgun is getting inaccurate readings. When using a probe thermometer, it reads higher than what the IR gun is reading in some spots, reaching over 96 degrees, so currently, until I have this sorted out, I have turned the uth off