Is it ok to rest the tubs on the heat tapes contact points?

[Dylan_]

I was setting up my new enclosures to transfer my snakes into and realized the tub lifts up a little bit because it's resting on the contact points where the wire is attached to the heat tape and taped over with black electrical tape. Is this ok or is it dangerous to have the tub resting on top of the contact points?

Are you worried about the heat tape melting the plastic that won't happen any heating Source should be controlled by a thermostat and they don't get hot enough to melt plastic anyway at least they shouldn't it takes over 200 Fahrenheit before a plastic would even start warping it's fine if it's touching it it's not going to hurt anything

Sent from my SM-G965W using Tapatalk