Quote Originally Posted by ckuhn003 View Post
Some last minute questions as I await the arrival of my new BCI (tomorrow).....

I have the quarantine tub setup w/ two hides and a water dish. It's been sprayed w/ PAM over 24 hours ago.

Humidity is around 65-70%. I had my hot side floor temp set to 88 degrees but I ended up bumping it to 91 because the paper towel substrates were only reading in the low - mid 80s. I know with other substrates, a snake can burrow and reach the floor but w. paper towels is there a different protocol here? Are those temps good?

Also, I put about 4 holes on all 4 sides. I would assume this is enough ventilation for him?

Any other suggestions are appreciated.
Good on humidity.

Hot side floor temp is better at 88F than 91F.

BCI's like 86-88F or so. 90F is pushing it for them and 91F probably means she won't want to be there.

My hot side, depending one where under the RHP and Heat tape I measure (I use both on the hot side of my 6X2 Boaphile), ranges from about 86-89F, with an average of about 88F.

I bet you cannot wait!

Make sure to post pictures and then let him be for a while!

Good luck!