Tank size questions

[reptilemom25]

Ok so there may be some confusion. The UTH is a reptitherm for a 30 gal size. There is no probe, no dial, nothing just the heater and a plug. I plugged the UTH into a 1000w Zilla temperature controller (TC) now the TC will switch on and off whatever heat source is plugged into it when it reaches the desired temp. I did go ahead and take the TC probe out from underneath the substrate. I buried it underneath the substrate because that's what the instructions had said to do.

I will go and get the ceramic for heat and a blue light although the research I've done has said snakes don't see light in the red spectrum. I can for sure get a smaller wattage of bulb.

Lucy has eaten for me 4 times now. She eats every Friday around 5pm.

I do know the not handling after eating, I give her a good 48 hours after food before I even think about handling. The only time she gets touched after eating is to transfer her back to tank from feeding tub

I do know they are nocturnal creatures which is why she only comes out at night which is good for me because I sleep during the day cause I work nights.

Her temps and everything have been fine so far just been fine tuning and getting the extra equipment such as UTH but according to thermometer which I have a temp gun and have had one to spot check temps since I've had her was always under the impression that the digital temp probe was a better for keeping an eye on temps inside her hide because I don't want to go in a couple times a day and lift the hide to check temps



Sent from my SM-G955U using Tapatalk

Did you put the probe between the UTH and the glass, or just unbury it? Between the UTH and the glass is the only way to assure the glass doesn't get too hot and burn your baby.