» Site Navigation
4 members and 864 guests
Most users ever online was 47,180, 07-16-2025 at 05:30 PM.
» Today's Birthdays
» Stats
Members: 75,908
Threads: 249,107
Posts: 2,572,125
Top Poster: JLC (31,651)
|
-
BPnet Veteran
About V-70 rack.
Hello,
I don't know if this is the right forum to post, but I had question about the rack I bought.
So I bought a rack from c serpents, V-70. I have one ball that is still not full grown yet, and was wondering if anyone know where to get the V-70 dividers.
I saw iris CB-70 dividers from reptile basics but I am worried it won't match the V-70 tub. Does anyone know where to get V-70 dividers?
Or any other ideas? except putting snake in separate tub with separate heat (I already have this in mind if there is no other way to work this out)
Like, smaller tub that still fit the height of the rack etc..
Thank you
Last edited by gusanr14; 07-27-2018 at 07:28 PM.
-
-
I use the v 70 tubs in my racks and use the Reptile Basics dividers. They fit well if you only use 1 of the 2 "t" support
brackets. If you wanted to use both sides it'd be easy to saw off a small piece. I didn't bother and I've been pleased with the fit and my snakes stayed put.
-
-
Re: About V-70 rack.
Had to use tapatalk to take the photos...Because the fit is tight, I used the divider as shown. I could've used a hacksaw to trim the divider so both ends could have a "t" because the PVC cuts nicely but there was no need. 
Sent from my SM-G950U using Tapatalk
-
-
BPnet Veteran
Re: About V-70 rack.
 Originally Posted by Tila
Had to use tapatalk to take the photos...Because the fit is tight, I used the divider as shown. I could've used a hacksaw to trim the divider so both ends could have a "t" because the PVC cuts nicely but there was no need. 
Sent from my SM-G950U using Tapatalk
does it balance well? I mean, one side has no "t" to hold it in place, doesn't it move around?
-
-
It never wobbled or toppled. If one snake really tries it can move the divider off center by a couple inches but I also used hides with my guys when they were smaller so the hides would prevent any major space loss. Also, even without hides in there my two seemed pretty content with their boundaries and I only had to slide it back a few times over the 5 months they shared one tub.
-
-
BPnet Veteran
Re: About V-70 rack.
 Originally Posted by Tila
It never wobbled or toppled. If one snake really tries it can move the divider off center by a couple inches but I also used hides with my guys when they were smaller so the hides would prevent any major space loss. Also, even without hides in there my two seemed pretty content with their boundaries and I only had to slide it back a few times over the 5 months they shared one tub.
Thanks for the info, I just ordered it from reptile basics hope they work fine like you said! haha
-
-
Re: About V-70 rack.
Oh cool, good luck to you! I hope you like it as much as I do!
Sent from my SM-G950U using Tapatalk
-
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|