I posted this in my build thread entitled SWIPER gladiator but it might not have gotten a ton of views and I’m at the point where I need to either cut my backdrop down or let it be.
I have built Styrofoam backdrop. To emulate a Roman Colosseum… The back wall of the PVC enclosure has slotted grooves which I Soum is to let Erin and I both corners and also in the middle at the top… My backdrop covers up those slots I can certainly trimming down about 3 inches if needed but I have humidity issues anyway my house so I wonder if covering those up would not be such a bad idea anyway pics below… Any thoughts?
With unpainted backdrop sitting flush against back wall:
Tilted slightly down so you can see the upper corner slots and upper middle slots
I suppose I could leave it as is and monitor humidity to see how it goes then if I need to change it out I could take everything out and do it it would just take some work to do that… There are air slots on the side of the tank just not sure if that would be enough.
Sent from my iPhone using Tapatalk
Reply With Quote