Ball python plastic tub holes?

[oodaT]

Start with the least amount of holes you can, check humidity and add more if needed. Wal-Mart carries these accurites, just picked up 5 more at 8 bucks each.

Sent from my SM-G955U using Tapatalk

[tttaylorrr]

I worry about the fumes and gases that comes out of melting plastic O_O. Melting acrylic releases Formaldehyde particles and gas... melting ABS release styrene particles and gas. No XD!

as you should be! but being safe around those plastics is very easy once you practice proper safety!
IMPORTANT PSA: ONLY use a soldering iron on plastic in a WELL-VENTILATED area with a fan to push the fumes AWAY from you!!!

if you can smell plastic, you're doing it wrong!!!

i love you all.

[Godzilla78]

Just do the plastic melting outside. Simple solution. Jeez


Sent from my iPhone using Tapatalk

[redshepherd]

I solder at least 10 holes total for a 15qt, and just add more as needed depending on how the humidity is turning out.

[Godzilla78]

Start with the least amount of holes you can, check humidity and add more if needed. Wal-Mart carries these accurites, just picked up 5 more at 8 bucks each.

Sent from my SM-G955U using Tapatalk

Thanks for the Meter buying tip.


Sent from my iPhone using Tapatalk

[tttaylorrr]

Just do the plastic melting outside. Simple solution. Jeez


Sent from my iPhone using Tapatalk

the high today was 6°

[Ashleigh91]

Just do the plastic melting outside. Simple solution. Jeez


Sent from my iPhone using Tapatalk

It's -40°C where some of us live! Screw outside.


In all seriousness though, I second what everyone else has said. Set it up with the accurate hydrometer, see what the humidity sits at with the holes you have and just add more as needed until you hit your desired humidity.

Sent from my SM-G930W8 using Tapatalk

[Ashleigh91]

the high today was 6°

.... -41 This morning. I'll trade you?

Sent from my SM-G930W8 using Tapatalk

[tttaylorrr]

.... -41 This morning. I'll trade you?

Sent from my SM-G930W8 using Tapatalk

no ty. LOL.