Uth not sticking properly

[Sunnieskys]

So looking at the ultra therm uth they range between 65-95 degrees so you don't need a tempstat? And will I have the same issue of a bubble where the probe goes?

[tttaylorrr]

So looking at the ultra therm uth they range between 65-95 degrees so you don't need a tempstat? And will I have the same issue of a bubble where the probe goes?

they do not get as hot as other UTHs and they say you don't need a thermostat, but i still use thermostats with mine. yes there is still the bump issue with the probe, but i've never had issues with it. i've aluminum taped the UTH tight enough to the enclosures and placed the probe off center from where the snake will be spending its time so it's not really an issue (3/4 of my enclosures have the bump; T8 has a probe channel for it to sit in).
there's ways to remedy the bump issue if you're still concerned, however. is your enclosure raised off of whatever it's on? you could get two blocks of styrofoam for the enclosure to sit on and cut a channel into the one on the hot side for the probe to rest in. you could also tape the probe wire to the underside of the UTH (facing the floor), but you can't tape the probe head itself.

[Sunnieskys]

It's a 20 long so it is raised but I'm confused about the styrofoam? im not picturing how that would work? I need a crayon drawing Taylor lol

[tttaylorrr]

It's a 20 long so it is raised but I'm confused about the styrofoam? im not picturing how that would work? I need a crayon drawing Taylor lol

hang on...

i only had colored pens

[Sunnieskys]

Rofl RAD! Now where would the uth go with the styrofoam?

[tttaylorrr]

Rofl RAD! Now where would the uth go with the styrofoam?

taped to the bottom of the enclosure and resting on the styrofoam. so you have an Enclosure, UTH, probe, styrofoam sandwich.

EDIT:

[Sunnieskys]

Ah gotcha. I'll do that. Thank you for the drawing!

[Dawntup]

Can we delete posts?

[Dawntup]

they do not get as hot as other UTHs and they say you don't need a thermostat, but i still use thermostats with mine. yes there is still the bump issue with the probe, but i've never had issues with it. i've aluminum taped the UTH tight enough to the enclosures and placed the probe off center from where the snake will be spending its time so it's not really an issue (3/4 of my enclosures have the bump; T8 has a probe channel for it to sit in).
there's ways to remedy the bump issue if you're still concerned, however. is your enclosure raised off of whatever it's on? you could get two blocks of styrofoam for the enclosure to sit on and cut a channel into the one on the hot side for the probe to rest in. you could also tape the probe wire to the underside of the UTH (facing the floor), but you can't tape the probe head itself.

Hi, just wondering about not applying tape directly to probe, what is the reason? I have mine taped to underside of mat right now, getting good temps..

[tttaylorrr]

Hi, just wondering about not applying tape directly to probe, what is the reason? I have mine taped to underside of mat right now, getting good temps..

Spyder Robotics Herpstat user manuals specifically state to not cover the probe head due to possible inaccurate readings. if the best thermostats on the market cannot have the probe head covered, then i'm not taking chances on a lesser thermostat.