Quote Originally Posted by Sauzo View Post
So even when you switched probes to opposite channels, channel 2 still went up to 136ish?

Temp gun the spot where the probe is and see if your temp gun is reading the same or very close to the Herpstat.
Ok, I'll try and lay out what I'm seeing because I'm having a hard time understanding it.....

Original Setup:

Channel 1 (Cool side): Herp Setting (95). Herpstat Reading (136)

Channel 2 (Hot side) : Herp Setting (100). Herpstat Reading (100)

New Setup: (I taped the probe to the UTH which was reporting the 136 above). I also switched the probes on the back of the HerpStat but kept them the same under the UTH

Channel 1 (now hot side): Herp Setting (95). Herpstat Reading (81). Temp Gun Reading (80) Heat needs to penetrate glass bottom

Channel 2 (now cool side): Herp Setting (100). Herpstat Reading (99). Temp Gun Reading (87) Heat needs to penetrate pvc bottom

So to me it looks like it's an issue w/ the channel (1) in the Herpstat and not the probe. Anyone else see it this way??