RHP Hot spots

[Sauzo]

Moved the probe to hotside and seems to be much more stable. Only concerns- ran the probe through the hole for RHP cord as seen mentioned here. Herpstat mentions keeping cords separated as much as possible, is this an issue?
Also since the cord is on top do T8' stack with a slight gap or no gap? Want to make sure cord doesn't get smashed.

I run 2 Herpstat 2 and 2 Herpstat 1 and I got probe wires and plugs going all over and it all works fine.

I have my T10s all stacked with no gap but I use flexwatt for everyone. If you didn't have your RHPs drop shipped to AP and had them install them with routed channels in the roof for the cords, my best advice is run the plug wire inside the cage on the roof and secure it with cable clamps and then drill a hole out the back wall. Also you can do like what Ali at Ap told me and butt the RHP against a side wall and run the plug wire out the side and then secure it outside the cage along the side wall.

Now with all that said, if you already got the hole and stuff on the top of the cage, then you will need to do what Ali also told me and that is buy furniture pucks. measure how thick the plug wire is. Remember though that you don't want too tall or the lineup/lock pins wont work and then your cages can shift.