Quote Originally Posted by JMoriarty View Post
I put aluminum tape between the tub and the pad because I was worried about it getting too hot. Idk what to do at this point. Do I remove the tape and take the chance or is it even causing the issues? Gah frustrating!
Foil tape is not going to change the heat output at all..............
Where are you taking your readings from and with what?
Have you tried a different dimmer? I have seen and had bad ones.



Quote Originally Posted by kylearmbar View Post
Sometimes I notice this, then I look in the bin and the probe got moved off the hotspot and was no longer right against the plastic like it should be, it tends to get pulled a around a little with the sliding in and out of the tub.
Nothing should be inside the tub unless it is an unused tub. Totally bad idea.