I use f10scxd wash with hot water (1:250) and a sponge to wash the full area and rinse with water two or three times. (As per the instructions) Then F10sc to disinfect but the instructions say to flood the area. I was spraying but it requires many repeats I found flipping it over I could soak the area and not need to constantly re apply on the upper surface. I have tried everything but the detergent then water rinse and saturated disinfectant upside down I found far easier.

Failing to clean first renders disinfectants neutral. With the amount of liquids I find it easier to remove the heat tape completely water soaks under it and around the connections and makes me uneasy. The new heat tape (TNG) I just got a sample of is not sealed at all so there is no question of it needing to be removed.


Sent from my iPhone using Tapatalk