» Site Navigation
2 members and 843 guests
Most users ever online was 47,180, 07-16-2025 at 05:30 PM.
» Today's Birthdays
» Stats
Members: 75,905
Threads: 249,104
Posts: 2,572,100
Top Poster: JLC (31,651)
|
-
-
-
There are a few threads in the DIY forum and there is also this http://www.arbreptiles.com/cages/incubator.shtml
-
The Following User Says Thank You to Stewart_Reptiles For This Useful Post:
-
-
The Following User Says Thank You to Quantum Constrictors For This Useful Post:
-
-
-
Here is our build (eggs are cooking now ):
www.gpreptiles.com // YouTube // Facebook // Instagram
Normal 1.3 // Mojave 0.1 // Pinstripe 0.1 // Spider 1.1 // Lesser 1.1 // Clown 0.3 // Pastel Clown 1.0 // Fire Fly 1.0 // Pewter 1.1 // Pastel het. Clown 1.0 // Dinker (probably YB complex) 1.2 // Kingpin poss YB 1.1 // Enchi Calico 1.0 // Pied 0.1 // Albino 0.1 // Cinnamon 0.1 //
Red Tail Boa het Kahl Albino 1.1
-
-
Incubator Builds?


Here's the incubator I made out of a cooler.
-
-
-
-
-
-
Re: Incubator Builds?
 Originally Posted by snakesRkewl
This is our smaller incubator, it's a redbull true cooler.
It has 2 strips of 3 inch heat tape against the back wall running vertical.
A false wall placed about an inch and a half from the back wall.
A bathroom ceiling fan plugged into a rheostat to control airflow.
A smaller fan would work, but I love the ability to fine tune the airflow.
The fan sucks air from the top downwards over the tubs and pushes it through a hole in the bottom of the wall, over the heat tape and up to the top where it is blown out into the inc to repeat the cycle.
The probe for the herpstat is put through the top and it is hanging in front of the heat tape behind the wall, SUPER STABLE.
We did this same build with our larger incubator using 11x12 inch heat tape.
Ceiling fan, not recommended for any incs smaller than this one, they create heat ...
Top hole where heated air comes out, and where the thermostat probe is.

What is the model of those bins with the blue and green latches? I haven't seen those . Thanks
-
-
This is Mine: http://ball-pythons.net/forums/showt...-with-Pictures
With cost... some mistakes made.. learning curve... and corrections...
-
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|