Accurite Thermometers

[Willie76]

Where at Wal-Mart can you find the Accurites? Pet Dept? Gardening Dept?


Sent from my iPhone using Tapatalk

[Annarose15]

I have found them by air conditioning filters and outdoor timers (inside the store, not gardening).

[Willie76]

Thanks. Headed there now.


Sent from my iPhone using Tapatalk

[The Serpent Merchant]

By the lightbulbs

[Willie76]

Found them. Bought one for each enclosure. Now, unit on warm side since unit also measures humidity and probe on cool side or vice versa?




Sent from my iPhone using Tapatalk

[The Serpent Merchant]

I usually set them up opposite, probe on the hot side (directly over the heating pad/under the heat lamp) and the unit on the cool side to measure the air temperature/humidity

[Annarose15]

I usually set them up opposite, probe on the hot side (directly over the heating pad/under the heat lamp) and the unit on the cool side to measure the air temperature/humidity

^ this. That is why the probe is so useful. Stick it to the glass/plastic on the floor, directly over the heat pad. Otherwise you're measuring the air temp, not hot spot.

[Willie76]

I use cypress substrate, about 1" through out. If I go directly on the glass over the UTH, won't that give me a higher read? I do have a thermostat coming for the UTH to measure and regulate the UTH. Do I not need to measure the "general" ambient on the warm AND cool sides at the snakes level?

[Griffith]

The air temperature should be about the same throughout the enclosure, so no, you do not need an ambient temp reading from both ends. You need the probe to be on the glass, under the substrate. If you are getting a reading of lets say 93 on the substrate, the glass could be at 110, 115 or so. What happens if it gets under the substrate and cooks ..... Probe should be as close to the heating pad as the snake could get, which is under the substrate

[The Serpent Merchant]

You need to thin out your substrate layer. a UTH isn't going to be able to heat through 1" of substrate. The maximum substrate thickness when using UTH's should be around 1/2" or less. This will minimize the difference in temperature, and allow your system to run more efficiently.