Finally got my cage set up

[satomi325]

Nice set up!
You can use a different substrate to boost humidity as well as the larger water dish. Coco husk or cypress mulch retain humidity really well.

Sent from my DROID RAZR using Tapatalk 2

[MrBrute]

I'm probably going to the manassas show too!

awesome!

- - - Updated - - -

Nice set up!
You can use a different substrate to boost humidity as well as the larger water dish. Coco husk or cypress mulch retain humidity really well.

Sent from my DROID RAZR using Tapatalk 2

aspen was the choice lol I'm sure I can spray it down right? That is what I did earlier. it's still at 38%

[MrBrute]

lookin' good. if i were you id empty the water out until you get him so it doesnt get nasty! good luck!

im trying to raise the humidity

[satomi325]

awesome!

- - - Updated - - -


aspen was the choice lol I'm sure I can spray it down right? That is what I did earlier. it's still at 38%

You can place some damp moss in the enclosure too if you don't want to switch substrates.

Sent from my DROID RAZR using Tapatalk 2

[ewaldrep]

just to double check, wouldn't the thermometer work better inside the cage where it can give a reading of the ambient temps as well as the probe on the hot spot? I'm not sure if you just have it out there for now but I thought I would ask.

[Ridinandreptiles]

awesome!

- - - Updated - - -


aspen was the choice lol I'm sure I can spray it down right? That is what I did earlier. it's still at 38%

if you want to spray down id suggest cypress...aspen tends to mold

[MrBrute]

just to double check, wouldn't the thermometer work better inside the cage where it can give a reading of the ambient temps as well as the probe on the hot spot? I'm not sure if you just have it out there for now but I thought I would ask.

the probe is inside the tank over the heater.

[martin82531]

the probe is inside the tank over the heater.

Humidity is measured at the unit itself not the probe, probe it's just for the temp.

Sent from my DROID4 using Tapatalk 2

[MrBrute]

Humidity is measured at the unit itself not the probe, probe it's just for the temp

Sent from my DROID4 using Tapatalk 2

Really? so I need put the whole thing inside the cage?

[martin82531]

Really? so I need put the whole thing inside the cage?

If you want to measure the humidity the unit needs to be inside the enclosure.

Sent from my DROID4 using Tapatalk 2