Quote Originally Posted by Simple Man View Post
Here's the cut sheet for my 41qt (2 sheets)




After much trial and error I recommend a 1/32 spacer to be used on both edges of the tub while assembling. This gives an easier sliding tub. I tried some household things and they didn't work well. I ended up using two strips of balsa wood.

Regards,

B
Hey everyone! So I plan on building my xpvc racks in a few weeks. I'm building some to hold 60qt sterilite bins at target, for which I need 35x19 shelves. So my question is, after changing the specs above, I noticed I would have four support legs (the frame ya know) that would be attached to the shelves. The four legs would be 6.5 in thick. Would that be enough to support the weight of the rack? Or should I revamp my specs?