Finished Incubator help with fan/prob?

[Kylegep]

Ok thank you!

[jsmorphs2]

Oh, and I forgot to ask, what type of light is in side? Just make sure when you set up the temps that the light is off and you keep it off. It can raise the temp inside and the light will just encourage mold and bacteria growth.

[Kylegep]

It's one that wa built in at the top and it's off

[Raverthug]

I'd put it in a middle egg box. Just label it so you don't forget and pull the probe out with the box.

I would personally do it against the middle wall. This way you dont have to remember what tub its in and if you choose to seal it you dont have to worry about that

[jsmorphs2]

I would personally do it against the middle wall. This way you dont have to remember what tub its in and if you choose to seal it you dont have to worry about that

That would work too. I'd be sure to have really accurate thermometers in the middle tubs on each side to monitor the egg temps.

[Kylegep]

I would personally do it against the middle wall. This way you dont have to remember what tub its in and if you choose to seal it you dont have to worry about that

Would you put it on the middle of the middle wall?

[Annarose15]

Would you put it on the middle of the middle wall?

Yes, directly on the flexwatt that it will be controlling.

[Raverthug]

yes in the middle but not on the flexwatt so you can measure the ambiant air

[Kylegep]

Ok so I did that and the with the fans it was only .5 degrees off from bottom to top. But now the fans are raising the temp is that normal?