I personally would get another hide just like you have on the left side of the tank and put it where the half log is. I would also remove the half log. A lot of pet stores keep the half logs in their tanks so the customer can see the snake. I don't think they make the best of hides because they are not that secure. That way your ball python will not have to sacrifice being cold vs. being in his preferred hide. I would also lower your hygrometer to approximately one inch or so above the bedding. That is actually where the snake is and you would get a more accurate reading where the snake is.
As far as your humidity goes you can go to Lowe's or Home Depot and get a pice of plexiglass (cut to fit......they will cut it for you) and place over the water bowl. Make sure the plexiglass covers about two-thirds of the top of the tank. Another issue that you are having with humidity is your aspen bedding. It is very dry and does not hold humidity very well. Cypress mulch is great at holding humidity. A UTH is a better alternative for providing heat than the heat lamp because the lamps suck out your humidity.
Other than that it looks like you have a good setup. This is all my $0.02.
Good Luck!
Reply With Quote