Quote Originally Posted by iCandiBallPythons View Post
My 32q racks I use belly heat and I do the flexwatt this way, so when I built a baby rack I just applied the same, so far Ive had no problems, I just made sure the flexwatt was very tight against the back of the rack. Keep in mind though that with any rack the flexwatt temp will differ from the actual temp inside the bins.
Ok thank you. I was just worried that if I put the Flexwatt too close to the melamine it would pose a fire hazard if not covered with aluminum tape. I bought a couple washers to use as a spacer between the melamine and the flexwatt, but maybe I dont need that then. My boyfriend is heinously concerned I'm going to burn the house down.