Quote Originally Posted by snakesRkewl View Post
Becuase the holes are a bit low, it might hold humidity more than you'd like, I put all of my holes towards the top, and about 30 holes per tub, and still have really high humidity.
If you add more holes, try adding them at the top.

If you tape the heat tape to the tub, you will not enjoy cleaning them over and over.

You may want to put a board down between tubs and under the bottom tub, and lay the heat tape on that, so you don't need to tape it on the tub at all.

I do this same thing, but I use locking tubs that cost a bit more, but then you don't need to worry about clips holding the lid on either
Ill have to see how it goes, for my tank i have now its horrible at holding humidity so I have to spray like 2-3 times a day... hopefully tubs make it much easier then that...
If it does turn out to be a problem ill probably put smaller holes up higer in between the holes i already have. (it would be 38 holes a tub, if i do 9 smaller ones on each side)

lol... im like inbetween the stage of needing a rack and not. I would have made one but a two tub rack isnt very necessary... I have to keep them lifted up though so air gets to the heater. I used skate board wheels for the top tub.. I need to find something for the bottom one...

Ill probably end up taping them on just because It would be a hassle for me to have two random boards just on and under my tubs that I have to move around all the time to get in the bottom tub. I dont think it will be that hard to just un plug the heater to move the tub for cleaning.

I should have gotten locking tubs I didnt really look for them but... yeah... I dont know if they had 41 qt locking tubs either. Eventually i wont need any lids once i get a rack lol.