About V-70 rack.

Hello,

I don't know if this is the right forum to post, but I had question about the rack I bought.
So I bought a rack from c serpents, V-70. I have one ball that is still not full grown yet, and was wondering if anyone know where to get the V-70 dividers.
I saw iris CB-70 dividers from reptile basics but I am worried it won't match the V-70 tub. Does anyone know where to get V-70 dividers?
Or any other ideas? except putting snake in separate tub with separate heat (I already have this in mind if there is no other way to work this out)
Like, smaller tub that still fit the height of the rack etc..
Thank you

I use the v 70 tubs in my racks and use the Reptile Basics dividers. They fit well if you only use 1 of the 2 "t" support
brackets. If you wanted to use both sides it'd be easy to saw off a small piece. I didn't bother and I've been pleased with the fit and my snakes stayed put.

Had to use tapatalk to take the photos...Because the fit is tight, I used the divider as shown. I could've used a hacksaw to trim the divider so both ends could have a "t" because the PVC cuts nicely but there was no need.https://uploads.tapatalk-cdn.com/201...9a4ee31c79.jpghttps://uploads.tapatalk-cdn.com/201...d28bf2e048.jpg

Sent from my SM-G950U using Tapatalk

Quote:

---

Originally Posted by Tila

Had to use tapatalk to take the photos...Because the fit is tight, I used the divider as shown. I could've used a hacksaw to trim the divider so both ends could have a "t" because the PVC cuts nicely but there was no need.https://ball-pythons.net/forums/cach...9a4ee31c79.jpghttps://ball-pythons.net/forums/cach...d28bf2e048.jpg

Sent from my SM-G950U using Tapatalk

---

does it balance well? I mean, one side has no "t" to hold it in place, doesn't it move around?

It never wobbled or toppled. If one snake really tries it can move the divider off center by a couple inches but I also used hides with my guys when they were smaller so the hides would prevent any major space loss. Also, even without hides in there my two seemed pretty content with their boundaries and I only had to slide it back a few times over the 5 months they shared one tub.

Quote:

---

Originally Posted by Tila

It never wobbled or toppled. If one snake really tries it can move the divider off center by a couple inches but I also used hides with my guys when they were smaller so the hides would prevent any major space loss. Also, even without hides in there my two seemed pretty content with their boundaries and I only had to slide it back a few times over the 5 months they shared one tub.

---

Thanks for the info, I just ordered it from reptile basics :) hope they work fine like you said! haha

Oh cool, good luck to you! I hope you like it as much as I do!

Sent from my SM-G950U using Tapatalk