Hi,

I see a lot of people recomending the acurite in/ out humidity gauge from wallmart at around $12.

By the way the analogue humidity gauges are just as inaccurate as the temperature ones so I would ditch it when you get the digital.

Here is a very good post by Argentra which shows the unit I am talking about - and also the thermostats to control the UTH.

You can also use a rheostat/ dimmer to control the UTH but those need a lot of adjusting and constant checking if your room temps aren't super stable.

You will probably need something to control it as most types of UTH can reach 120f+ unregulated and you only ever want the snake exposed to 95f if possible to avoid the possibility of burns.

When you get the acurite (or whichever brand you choose) measure the temps directly on top of the heat mat (under the substrate) inside the warm hide as this is the warmest temps your lil guy should be able to reach.

Try and adjust the heat source until those temps are around 93-95f then adjust the thickness of the substrate until the temps inside the hide on top of the substrate are 90-94f.

The probe is obviously the best way to measure those - and while it is doing that the base unit can be placed at ground level on the cool side to measure low ambients and humidity. Give it an hour or so to stabilise after you open the tank so you are getting a true reading.

Once you have got the warm end hide temps right them switch the probe to inside the cool end hide and try and get the temps there in the 80-83f range.

Once those are sorted you should be set.

And if you have any probs just post back with pics/ details of your enclosure and people will be able to offer specific advice to help you.


dr del