Adhesive for snake tubs

[Sloburn]

I am building my own racks and buying my tubs a couple at a time untill I am finished. I am wanting to use some PVC for cup holders in the tubs. What would be a good adhesive that would be good for the snake .

[Royal Morphz]

great idea its been asked before but alas there are no adhesives id trust in a tub

[stangs13]

I'm not sure if the couplers have a bottom, but you could Velcro them down.

[m00kfu]

Are you looking for a permanent adhesive or a temporary one? If this is a permanent modification you want to do, JB weld should do the trick. Just make sure to let it cure fully (24-48 hours) before dropping a snake in the tub with it.

As far as the velcro idea goes, I wouldn't suggest that. The velcro would be just like putting a piece of tape in there. If it comes loose it could end up adhering to the snake, and nobody wants to deal with that.

[dr del]

Hi,

I think people have had good experiences using a hot glue gun - and it can be twisted off later.

What are you planning to use as a substrate?


dr del

[TooManyToys]

Like Derek said, a hot glue gun will work best. Velcro will be a mess to clean.