Yeah no problem!

The heat panel is on the left hand side of the cage on the ceiling. Tight into the left side. And tight to the back wall.

Its a warm day in here today and my room thermostat is reading 76. The room dips down to as low as 72 on some nights though. And its still ok.

Ambient temps in the cages are 80 and 81.

Cool side temps are both at 80.

Warm side temps are 86.

Ive got flexwatt on both the warm and cool sides of the cages. Set at 86 on the warm side. And 80 on the cool side.

The RHP is just keeping my ambients up in the cages for the most part. When the room gets colder and the panel is running more. The floor heats up slowly and the probe under the cage for the flexwatt shuts that stuff off.

The floor stays right at about 86 to 87.

I put my RHP probe between the floor and the panel set at 82. And that keeps my ambients right. And keeps the floor right at about 86. Kinda weird! But those temps are what i want for my blood pythons.

Its just hanging down on the edge of the panel.

Also you wont be needing all the wattage out of your RHP. Mine run at about 10 to 30%, 99% of the time. So figure 10% of a 65w panel is 6.5 watts? 6.5 x 3 panels is not even 20 watts. Theyre very energy efficient.


Did i miss anything?