I will have to take pics of the assembly... very difficult to explain but I will try.

I used a piece of 1/2" hardware cloth that was 9" x 24". (looking at it long ways) make your first fold at 9 inches. then make your next fold 2 1/2 inches from the first.... you just made the front, bottom, and back. I cut 7 sqares off of back side on both left and right side... then you fold the front on both sides to create the sides of the feeders. the extra three inches on the back top are what i bent to hang over the tank edge.

Sorry guys, very difficult to put into words. did this make sense to anyone? try it with a piece of paper first... it will make sense then.


MIke