how to run thermo wires in a rack?

[CntrlF8]

Just got my rack today, and I'm having a hard time setting up the tubs. I can't run the wire outside around the top of the tubs like I was before, and there's way too much to just leave inside... what do you guys suggest?

[CntrlF8]

Anyone?

[CntrlF8]

Hate to bump this again, but I really need a little guidance...

[Freakie_frog]

What kind of rack is it???

[syclone]

Can you drill a small hole behind the tub and run out the back?

[Kagez28]

i wrap the wires up around the stand for the acurite. they are are out of the way.

[syclone]

its for the acurite, I see, I thougt you were talking about flex watt wiring, sorry

I usually just wrap up the excess wires and use a wire tie and place beside the tub in the rack.

[CntrlF8]

its for the acurite, I see, I thougt you were talking about flex watt wiring, sorry

I usually just wrap up the excess wires and use a wire tie and place beside the tub in the rack.

It's a reptile basics rack, 4 tub Iris sweaterbox rack.

I would normally do exactly what you described, but the gap between the tub and next shelf up is so tight I can't even get the wire out!

I'll probably do as suggested and wrap it around the stand, or make an additional hole for it.

[mmchoppers]

I leave the accurite in the tub.

[CntrlF8]

Has anyone considered cutting and splicing the wires for the probe to make it shorter?