I've got a T3 with belly heat at one end and a circular mesh at the other. The bellyheat will be connected to a proper on/off thermostat and probe placement is obviously easy. Hopefully with one CHE on low power humidity will be less of an issue but I will keep it under review. Would you suggest I place the CHE thermostat probe on the floor at the cool end or higher up to measure air temps?
I'm also a bit concerned that the che may get the mesh hot enough to burn the nsake if he touches it, is this likely to be an issue? Did you rest the che holding directly on the mesh? What wattage of che did you use?
Cheers,
Ed