cb-70 rack questions

[johnabrams82]

im building a cb-70 rack and i have the heat tape but i cant seem to find the metal that goes over it.. is the metal necesary? can i just use the heat tape or do i need the metal covering for it?

[mlededee]

do you mean the metal clips like this: http://www.reptilebasics.com/store/p...at=248&page=1? or aluminum foil tape like this: http://www.reptilebasics.com/store/p...at=248&page=1?

[firehop]

im building a cb-70 rack and i have the heat tape but i cant seem to find the metal that goes over it.. is the metal necesary? can i just use the heat tape or do i need the metal covering for it?

Do you mean the metal like in Bailey's setup? If so you need to go to home Depot or Menards or Lowes and buy unpainted flashing. You then need to cut it with tin snips. Wear gloves, trust me on this I used to work with tin all the time and you will thank me later. I built a jig (a tool that you could use as a sort of template). It will make it much easier.

Hope this helped

[johnabrams82]

like the tape i guess. it was sheet metal that they were using in the guide but i supose that tape would work

[johnabrams82]

Do you mean the metal like in Bailey's setup? If so you need to go to home Depot or Menards or Lowes and buy unpainted flashing. You then need to cut it with tin snips. Wear gloves, trust me on this I used to work with tin all the time and you will thank me later. I built a jig (a tool that you could use as a sort of template). It will make it much easier.

Hope this helped

yes bailys is where i got the guide.

[firehop]

its just sheet metal.....the bending kinda sucks unless you have a break but it will work out just take your time.

[dalvers63]

I think what you're looking for is Aluminum tape, used to hold ducts together. It's great stuff and I find it sticks to ANYTHING.

You can find it at hardware stores such as Lowe's and Home Depot. Here's a link to some from one of their sites.

Aluminium Foil Tape

You can also buy it from The Bean Farm. You will find it under their Heating section on the bottom of the page

I've found the cheapest place to get it is at the hardware store. There are a couple different thicknesses. i've always used the thinner stuff and usually find a roll for around $6

[lord jackel]

If you are using Tim's plans you MUST use the metal...it is what supports that flex across the 2x2's...but you don't need to use metal galvanized rolls and try and bend them (pain the the you know what)


Instead, go to Lowes or Home Depot and in the wood area they sell 8' aluminum wall studs...you can cut them to length and then just notch the ends so they sit in between the 2x2's. (then continue wth Tim's instructions)

[johnabrams82]

ok so the metal is a must. whats the cheapest way to go i think those aluminium studs would be expensive. thanks for the help guys ill figure something out. may have to wait til payday though.

[lord jackel]

ok so the metal is a must. whats the cheapest way to go i think those aluminium studs would be expensive. thanks for the help guys ill figure something out. may have to wait til payday though.

They aren't that bad...about the same as a wood 2x4. Here in Indiana they run about $5 per 8' piece. They are made of alumium so they are light.