Quote Originally Posted by AzureN1ght
For those of you who tape your flexwatt to the bottom of the tub, and then the probe to the underside of the flexwatt--do you remove the flexwatt/tape for cleaning of the tub? If so, have you ever had it tear? If you don't remove it, don't you worry about electrocution or shorting out?

I was going to tape the flexwatt to the bottom of the tub, then the probe to the flexwatt. Is it equally as effective leaving the flexwatt "loose" and wedging the probe between the flexwatt and the tub?

I'm trying to get my tub set up and tested so I can pick Auryn up in a week or so, so I'd like to get a system down.

Any advice/opinions/experiences with the flexwatt taping issue would be appreciated

Thanks in advance!
Are you talking about putting flexwatt on the inside of the tub? I don't think anyone does that. Flexwatt goes on the outside of the tub on the bottom if you will be taping it to the tub. Place your thermostat probe on the bottom of the tub under any substrate and tape it down good.