I know Lowe's sells Acurite thermometer's that rock. All you have to do is tape the probe to the bottom of your enclosure over where the flexwatt is and put the Thermometer itself on the opposite side. It will read a "in" and "out" temp.... remember your "out" temp will be your hot side and your "in" temp will be your cool side. Also it reads humidity levels too. I hope that helps.


Also - just saw your above post. Get a dig therm first, set it up and then it should read what the temp is in your enclosure. After that get that reading, you can adjust your thermostat higher or lower till you have the perfect settings/readings.