I was thinking of this too; my Little Giant Still Air incubator has a wire mesh screen that sets into the bottom hanf of the styrofoam base, and the eggs could probably go ontop of some egg crate on this. I have them in vermi inside r-maids now; it was a clutch of 8, and 6 collapsed and died; the seventh is on its last leg I think, doing the same, but the eighth is still nice and white, candled nicely today, and has minimal collapsing/denting on top that is not getting any worse now. I now wonder if the media (vermi) could have possibly acted as a harbor for bacteria, and thus harmed the eggs that died? The inc. does have spaces in its base to add water, but unf. you can't just fill it, say, a few inches, as there are some vent holes and the water just comes out.

I have a question; how do you heat the water? I have tried making an inc. on the side, with an aquarium heater, and the water did not go over 80 degrees. It was only in a small styro cooler.