Thanks everyone for your comments and help! Matt and Adam are the BOMB!

I removed the RHP and relocated to the cool side along with changing its orientation from vertical to horizontal. I removed the electric tape I had covering the probes and just taped the wire portion so that the probe was free. I then set the belly heat temp on the t-stat to 95 and the rhp temp on the t-stat to 84. I didn't put the substrate or anything back in just the plain plastic cage until I could see the temps stablize. I completed this at about 12:40 AM or so. It is now 2:18 and I went to check it before going the bed....

NIRVANA!

Cool side (RHP) temp on the t-stat: 83.7
Warm side (Belly Heat) temp on the t-stat: 93.7
Cool Side (RHP) via Accurite: 84.2
I broke the wire on the probe on the Accurite so I'm going to get another one tomorrow
Cool Side (RHP) temps via PE2 Temp Gun: variable temps in the 80s
Warm Side (Belly Heat) temps via PE2 Temp Gun: variable temps in the 90s. (A few areas if you took the temp directly on the heat cable were in the low 100s. Nothing over 100.7 that I could find. AP says that's normal when Jamie asked on the Faunaclassfieds forum.
Humidity (with nothing at all in the cage): 47%

So it looks alot better. I may have a few adjustments when I add the substrate and the hides and everything back in but for now all looks good...I think.

What do you guys think?