Stubborn stuck shed

[Daisyg]

I think we're going to need to see this stuck shed you're talking about. This thread will show you how to post pics: https://ball-pythons.net/forums/show...-Post-Pictures. The temps you describe are too low. How are you measuring them? Pics of your enclosure and a description of your heating elements and thermostats would help us to advise you on how to make adjustments.

I can try to get pictures of the shed tomorrow but it'll be hard to see in a picture it's hard to see unless you're pretty close. I know my cool side is a little lower than I'd like but all my research says the warm side should be like 30-32? The basking spot is obviously warmer than that but I've never seen anything recommending it being higher than my current warm temp. The thermostat probe is on the warm side like an inch or two above substrate. There's a digital thermometer that's usually on the basking spot unless he knocks it off and an analogue thermostat on the cool side. I have tried increasing the temps to get the cool side cooler but it never seems to affect that side. The only "holes" are the ventilation bits the Viv comes with so it's not like a mesh top or anything.