Working on building a 3 stack setup.
These will be 3 Exo-Terra 36x18x18 (although this will apply to the 3 stack AP enclosure that's next)
Each enclosure will have belly heat and a Radiant heat panel in them
Should I use a Herpstat 6 to control the 3 RHP's and 3 belly heat pads or 3 Herpstat 2's??
Obviously The 3 Herpstat 2 will cost more than 1 Herpstat 6,
If the Herpstat 6 goes out I lose all heating in all enclosures, If I have 3 Herpstat 2, I might lose 1 enclosure but the other 2 will be fine (theoretically)
I can always swap a probe plug from the dead Herpstat to a good Herpstat to keep one source of heat going in two enclosures until the issue is fixed. (if that makes sense)