How's my Setup?? + I Need Advice!

[Hugsplox]

• Probe Thermostat #2

Measures the UTH on the INSIDE of the tank. stuck to the floor directly over the UTH so i can see how warm it is once it gets through the glass.

• Jumpstart Thermostat

what the UTH is plugged into. i keep it on the highest setting (105) because the heat that makes it through the glass only gets to about 95.

Sorry if I missed this somewhere, but where is the probe for your Jumpstart for the UTH? Just want to make sure that its sandwiched between the UTH and the glass and not inside the enclosure. If your snake moves that then you've got a UTH that's not regulated and it may burn your snake. Just ignore this if you've got it in the right place I just wanted to clarify.

Also to echo jm and nikkubus 95 is too hot for your UTH and a proportional thermostat on your CHE is going to solve a lot of your humidity issues.

I have a 40 breeder as well for my guy, Jumpstart on the UTH is set to 95 and creates a 90 hotspot in the warm hide.