Hi all, normally I would do a bunch of research and see if I could figure it out myself before posting but after tearing down and rebuilding my setup today and being absolutely exhausted and having bad brain fog from fibro setting in I can't even figure out what to google so I would really, really appreciate some help with troubleshooting.

I got a herpstat 6 and previously had it hooked up to one set up (on output 1) and it was working fine. Today I got everything reorganized so I could move everything off of cheap thermostats and onto the herpstat but it's not sending any power to the heating units. The sensors are reading correctly and all the heating units work.

I have it set to heating (dimming), no night mode or anything fancy. If you can help me figure out what's going on before I have popsicle pythons I will be so incredibly appreciative, thank you.