Maintaining the same thread, It is almost time to order heat tape and a thermostat. To any of you that have used a DIY incubator similar to this. The best I can figure this thing has about 40 cu ft of interior volume. I am going to use 11" wide flexwatt 110V and am questioning now if I go down both side walls and across the bottom, that would be around 14 ft of heat tape. Do you think this will be enough? if so, I will go with a Herpstat 1. If I also need to run a shorter piece down the back wall and up to the edge of the bottom strip, I would be adding another 7 feet and would go with the herpstat 2 since the 2 pieces arent the same length.

Opinions please?