» Site Navigation
1 members and 1,942 guests
Most users ever online was 6,337, 01-24-2020 at 04:30 AM.
» Today's Birthdays
» Stats
Members: 75,392
Threads: 248,759
Posts: 2,570,161
Top Poster: JLC (31,651)
|
-
Registered User
Themed bio active enclosure for Spilotes pullatus
As some of may know I kept a pair of Spilotes pullatus for a friend of mine who could not keep them any longer because of some extensive repairs he had to do in his old home where he originally kept the snakes. In 2015 I was still searching for a female for my male so he suggested to loan his pair to me for two years. I could try to get my male (or his) to breed with the female and he had enough time to do his repairs. I got his pair in February 2015. Unfortunately my male died a short time later because of an inflammation in his bowls (gastroenteritis) which didn't show any symptoms until a few hours before his death, so I had only the pair of my friend left.
In September 2015 I got a WC female from French Guiana and in June 2016 another pair also WC from French Guiana. The first female was kept together with the pair from my friend and I planned to keep the new pair in quarantine until my friend would get his snakes back (which was supposedly a little more than 6 month, so just about right for WC animals).
A few month later my friend told me that he was unable to take his snakes back because of some personal reasons. He offered me to buy the snakes, otherwise he would give them to a zoo who already kept Spilotes. I was really tempted to buy the female, but decided against it in the end, because my enclosure is OK for three snakes, but another female might have pushed it and I don't have enough room for another large enclosure. So he made the arrangements to hand them over to the zoo.
It took much longer for the actual handover because of a persistent infection with some worms, which took several treatments to get rid of, but finally I brought them to the zoo. If you are in the vicinity of the city of Dortmund (eg visiting the Terraristika expo in Hamm) you could visit the Dortmund Zoo and the Amazon house there and have a look at the pair I kept for more than 2,5 years.
Since the enclosure needed an overhaul, some of the plants were in there since the beginning in 2009 (and showing) I decided to it RIGHT.
When I planned the enclosure in the first place I chose endurable plants like pothos regardless of the origin of the plants. Now I want to build an enclosure which is completely bio active and themed as a Central / South American enclosure. The basic setup stays the same, the branches and cork tubs are the same as before. I chose only plants from this region. I added Xaxim panels for the backside of my enclosure as additional foothold for the climbing plants (and the climbing snakes as well) and added a special substrate to the sidewall. It consist of some kind of glue and substrate with seeds and spores in it, when it dries out and becomes solid you can begin to water it and after some time it is supposed to spawn moss and all kinds of different plants and creates a living sidewall. However, this substrate is originally used in smaller enclosures for dart frogs, so I found it doesn't work on large walls, at least some sections broke down after some time, but most of it is still on the wall, so I wait and see, if it stays there.
The ground consists now of two layers of pebble stones as drainage layer and on top of this a mix of soil and sand. The complete substrate is about 25 cm (10 inches) deep.
I use the following plants
1 x Dieffenbachia seguine
1 x Monstera deliciosa
1 x Monstera acuminata
3 x Marcgravia sintenisii
1 x Cissus amazonica
1 x Begonia thelmae
1 x Begonia microsperma
1 x Mimosa pudica
1 x Pilea involucrate
1 x Pilea spec. Panama
1 x Philodendron camposportoanum
1 x Philodendron spec. Französisch Guyana
1 x Nanodes/Epidendrum porpax
Since most of them are (still) rather small I hope they are able to survive the constant contact with three Spilotes pullatus. I just have to wait some time and might have to replace the plants which don't make it...
Here are some pictures of the building process and the plants I used
Drainage layer
The sidewall
The backwall with the first Xaxim panels
Some of the plants
Dieffenbachia seguine
Pilea spec. Panama
Begonia microsperma
Monstera deliciosa
Philodendron camposportoanum (front) and Marcgravia sintenisii (back)
Nanodes/Epidendrum porpax
Monstera acuminata
...
-
The Following 3 Users Say Thank You to Roman For This Useful Post:
John1982 (07-07-2019),Jules623 (09-30-2017),Prognathodon (10-02-2017)
-
Registered User
-
The Following 3 Users Say Thank You to Roman For This Useful Post:
John1982 (07-07-2019),Jules623 (09-30-2017),Prognathodon (10-02-2017)
-
Registered User
-
The Following 4 Users Say Thank You to Roman For This Useful Post:
John1982 (07-07-2019),Jules623 (09-30-2017),Prognathodon (10-02-2017),Starscream (11-15-2017)
-
Registered User
That looks like a pretty interesting enclosure to sit and watch.
-
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|