Help! Herpstat2 Heating up.

[maconridgedanes]

Please help w/ any ideas....

Just recently purchased a Herpstat2 and thought I had both temps dialed in (using temp gun). After unplugging, the unit and replugging into a new surge protector, one of my outputs has sky rocketed up to 112 degrees even though I have it set to 95 degrees on the unit. For reference, I have two UTH's (one on each side) on the underside of a PVC enclosure taped down w/ foil tape. The Herpstat2 probes are taped to the enclosure between the enclosure and the UTHs w/ a single piece of electrical tape. The tape is on the wire and not the actual probe.

Please help!

Check to make sure probe is against the UTH. If it's not in direct contact it may send a false reading.Tape it down over probe. Also make sure your herpstat temp is set correctly on the channel you have the probe set to. I had one lose setting when I unplugged it.

Sent from my XT1254 using Tapatalk