Thanks again for everyone's suggestions. I played with the temps again last night and it's starting to stress me out. Hopefully I'm overreacting....

Steps I took:

Taped the Herpstat probe (electrical tape on cord and not probe) to the underside of the glass area and covered with the Ultratherm UTH (using alum tape).



Set the Herpstat to 103 to achieve a warm spot of 93.1 (using temp gun). I put down minimal substrate (coco soft) which shows a temp of 85. The floor of the other side of the enclosure only reaches 75-76. Will these temps work? If not, any suggestions on how to raise them?

I didn't add any moisture to the substrate so it's very light and easily movable. So I would be afraid to increase the Herpstat setting because the snake would easily come in contact with the bottom of the enclosure and potentially burn.



Any suggestions?


Sent from my iPhone using Tapatalk