I'm using a herpstat 1. Once you get everything dialed in and the water heats up, the temperature holds great. My herpstat only runs between 9-12% power.
I considered not using a fan, but there is a bit of temperature variation from one side to the next. I figure I can use the fan once I switch to a bigger cooler anyways.
I have a small closet in my reptile room, I will probably convert it into an incubator in a few years. The room is already at 85 degrees, so it shouldn't be hard.








What thermostat are you using? Does the incubator seem to be holding consistent temperatures for you? I just bought a wine cooler that i'm getting ready to convert into an incubator...
Reply With Quote