Ball Python Eye Indent

[CharlesAndMonty]

Thank you for all the help everyone, I will invest in a thermostat for my heat pads and I will certainly raise the humidity and keep it at a stable 60% Turns out it was at around 35, which is not good, it's a dry summer here in Dundas. I will check my temps and all as much as possible. A quick update.. (I noticed the eye indent at about 9AM and made this post like 12 hrs later) it is now 12:21 i'm getting ready for bed and i decided to check him out, the dent has shrunk a bit after spraying his tank and placing him near his water getting him to drink some (Not forcing.. obviously) I will update you if I notice anything else, thanks again.
(PS. apparently the dent will go away after their next shed)

[Craiga 01453]

Just a few other things to consider: If you're using a stick-on analog hygrometer they are wildly inaccurate and basically useless (off by up to 20%)

I would strongly advise unplugging the UTH until you can get it regulated.

[CharlesAndMonty]

The thermometer I got was recommended by a trusted breeder, since I have other reptiles I have tested their thermometers on my BPs tank, it's the same throughout 2 other brand thermometers so I know it's accurate, thanks though.

[Craiga 01453]

Well, this breeder failed to tell you to buy a thermostat, which is probably the most important piece of equipment you will need.

And I inquired about your hygrometer

[CharlesAndMonty]

Good news, my breeder friend just got back to me and told me he'd help take care of the situation, 'take me under his wing' he said the indented eye is common and doesn't harm the reptile if treated asap, i'm undergoing his treatment schedule, thank all of you for helping me, you helped calm me down, if it wasnt for this thread I don't know what i would've done aha! He said it'll be as good as new by his next shed. I did forget to mention the hygrometer, i apologize. I'm not sure if you want me to update you or close the thread, your choice..

[Craiga 01453]

Glad to hear you're getting some guidance. I always think it's best to get info from multiple sources though. If you go by just one person's advice you could be headed down the wrong road. I'm not implying this is the case in this situation, just trying to help you and your animal out.

How long have you had your snake?

[CharlesAndMonty]

I've had my ball python since January, he's not my first though, I've had a corn snake since December. I got the Ball Python off that breeder.

[Craiga 01453]

Ok cool. If I can make a suggestion, I would say to read over the stickies on this forum on how to properly set up your enclosures. I'm guessing since your heat isn't regulated in your BP enclosure that your corns enclosure is also not regulated.

I honestly can't stress enough how important a thermostat is. If you care to search for snake burns online, it may open your eyes.

I'm not trying to sound rude, but it sounds like you've still got a bit to learn. We were all new once, so I understand, there is a lot to learn.

It's important to check your temps, etc... much more frequently than once a week.
Yes, snakes do burrow and your snakes are, in fact, touching the glass surface. Corns generally like to burrow more so than BPs. You ensured me otherwise, but the facts are snakes burrow and an inch of substrate isn't going to stop your snake from touching the glass with ease.
Your temps and humidity are both off a bit.
And yes, the eye indentation is a pretty simple fix. Despite what your breeder says, it is not common unless your husbandry is off. I've never had a snake with dented eyes...

I'm not trying to insult you or come down hard on you. I just truly want what's best for you and your snakes. The quicker you get things right the more you can stress less and enjoy your snakes. And I promise, once you have things dialed in it gets much easier.
Also, having a little cash stashed away for an emergency vet visit or malfunctioning equipment is always a good idea. If you need a hide in a pinch, a simple plastic bowl or from the dollar store or a butter tub with an entrance cut out will work for now.

Good luck! We're here and happy to help if you have any more questions...

oh...and again, I highly recommend unplugging unregulated UTHs

[dr del]

Sometimes they "bonk" their eye off something in the cage - it happened to one of mine while in shed.



Once she shed everything was fine.

[Craiga 01453]

Sometimes they "bonk" their eye off something in the cage - it happened to one of mine while in shed.



Once she shed everything was fine.

Thank you for sharing, I had never seen this. I love learning new things about these fascinating animals.