t-10 temp. woes

[Zincubus]

Hey everyone, so i finally got my new t-10 up and running with a RHP and herpstat 2, craft paper substrate and a 12" water bowl (shoutout to Mr. Sully). all seems well but i am having a heck of a time getting temps right. it has been running with water in the bowl for about 3 days now. i have the RHP set to 93* my t-stat is showing 89-90 on the hot side with about 80* ambient/cool side but when i check temps with my laser the floor of the hot side is showing 96-98??? also humidity is only 40%.

Any advise?

chappy

The thermostat dial is just a very rough guide to the ACTUAL temperature ... ideally you should have a thermometer with a wired probe on the warm area and randomly double check with your temp gun then adjust the dial on the thermostat accordingly .


Sent from my iPad using Tapatalk