If your significant other has problems visualizing, you might try something like this to help them out.
Well, i'm about to call this project finished. I found there was terrible moisture issue with putting insulation in the window from the high moisture room, so I dried out the room and used one of those shrink wrap kits to seal the insulation from the rest of the room. Hopefully I don't find mold when I pull them out again. Worst case scenario I'll just have to seal the windows permanently and won't be able to have fresh air in the summer like I wanted, but if that's what it takes... so be it. I started sanding the sink and realized my little experiment wasn't going to turn out as planned. There are just too many voids and I think it had to many big pieces that got ripped out during sanding. I just did a quick polish and sealed it. I think my only hope for something premium looking is to epoxy it as well. I will have to wait about a year before it is safe to put a finish like that on it though. So for now, i'm going to call it an industrial look. still will function just fine. Maybe in a year I won't even care lol. Room temp varies from 83 on the hot side to 80 on the far side floor. I don't know if I could realistically ask for better. Humidifier hits it's target without issue. Only thing I can think I am missing is a towel ring, would be nice to dry my hands after washing them lol. Might be adding animals today
Reply With Quote